1. Latex Rubber Extreme Full Coverage


    Date: 8/25/2015, Categories: Anal, Fetish, Gay Male, Author: Gaycrossdresser, Rating: , Source: xHamster

    This is not so much a story as it is a description of a full coverage latex catsuit that I once made. I thought that you people who have a latex fetish, as I do, and just can't seem to get enough, might find it interesting. I am gay, a Bottom and have a steady Boyfriend. I have only had a couple long term relationships where we progressed to the point of ditching the condoms and going bareback. This is about a suit that I made during one of those past relationships with a rubber loving partner. I love wearing full coverage latex catsuits, on their own, or under other rubber clothing. I shave my entire body and love the latex, and only latex, in contact with every inch of my skin. I like to have no skin to skin contact of any of my body parts, and no zippers interrupting that contact. I like it to be very supple, stretchy, non binding and yet skin tight so I usually make make my suits of about 2mm, (.008 inch) thick latex. Although not the suit I am writing about, you can see a regular suit of this thin material in one of my profile pictures. It's the one I am wearing while laying on my back on the green bed spread. I started with some .2mm transparent latex from MJ Trends. I made a classic hooded, gloved and footed face entry catsuit. The face opening goes from above the eyes to below the chin. The feet and gloves are attached and the suit is pulled on through the face opening and there are no zippers on the suit. The transparent gloves and attached cock and ball sheath ...
    were the ones listed as thin from Twist My Rubber Arm and are only .25mm thick, not quite twice as thick as a surgical glove. The feet were transparent latex toe socks that are much, much thinner than most and are sometimes listed on Ebay. Once in the suit, I would wear it for hours and hours. I made a very small hole in the tip of the sheath so I can use the bathroom while still completely in the suit I wanted to be a complete rubber being, be able to do every thing and still be completely and totally rubbered up. My suit design has a diamond shaped crotch panel that, when the suit is on and stretched tight over the body, allows the crotch to pull up snug into the crack of the ass so even my butt cheeks don't contact each other. I usually just make a small slit opening so I can be fucked. The stretch of the suit pulls the edges together and since it is up in my crack, can't be felt as an opening or seen unless I bend over and pull my cheeks apart. However, this suit I wanted as total rubber and even my holes rubbered, but I didn't want an internal anal sheath. What I did was make a short internal sheath to attach to the suit. Again, it was a very thin material, only a little over an inch in diameter. Being thin, it was big enough to stretch over my Buddy's cock and yet small enough that it didn't really bunch up where it entered my hole. It was about 3 inches long and tapered to about 2 1/2 inches in diameter at the inner open end. I bought two thick rubber &#034O&#034 rings, ...
«12»